Battery swap
Remove two T5 screws, slide out the battery sled and seat the new one. No heat, no glue.
- Time
- 5 min
- Tool
- T5
- Part
- $49
The Kinetic 01 opens with a Torx T5 driver. These guides walk through the most common repairs, and every part is sold directly at a fair price.
Remove two T5 screws, slide out the battery sled and seat the new one. No heat, no glue.
The display lifts off its sled once the same two screws are out. Calibration runs on first boot.
Both 1-inch sensors sit on one board with a single connector.
Every module for the Kinetic 01 stays in stock for a decade after launch. If we ever can't supply a part, we send you a free upgrade.
Batteries, screens, ports and boards for every model.
The Torx T5 driver in the box opens everything inside.
Nothing inside is glued, so nothing breaks on the way in.